Configure HTTP settings

Enable and control HTTP-based management access to the ASA by turning on the HTTP server, selecting the listening port, and specifying which hosts or networks are permitted, including considerations for HTTP-to-HTTPS redirect.

To access the ASA interface for management access, you must specify the addresses of all hosts/networks which are allowed to access the ASA using HTTP. If you configure HTTP redirect to redirect HTTP connections to HTTPS automatically, you must enable an access rule to allow HTTP; otherwise, the interface cannot listen to the HTTP port.

Before you begin

Follow these steps to configure HTTP settings:

Procedure


Step 1

In the edit ASA system settings page, click HTTP in the left pane.

Step 2

Uncheck the Retain existing values checkbox to configure the values for the shared ASA system settings policy.

Important

If the Retain existing values check box is selected, you can't configure the values as the fields are hidden. Security Cloud Control uses the existing local values of the ASA device for this setting and doesn't inherit from the shared policy.

Step 3

Check the Enable HTTP Server check box to enable the HTTP server.

Step 4

In the Port Number field, set the port number. The port identifies the port from which the interface redirects HTTP connections.

Warning

If you change the HTTP port on your device, it may cause some problems with its connection to Security Cloud Control. It's important to remember this if you plan to alter any settings related to your device's network connection.

Step 5

Click The configuration interface for HTTP settings displays options for changing the HTTP port, selecting the IP address version, and specifying the IP addresses and netmask for network access to the ASA. to add HTTP information.

  • Interface: Ensure the interface name specified here is the same on the ASA devices associated with this shared system settings policy.

  • IP Version: Select the IP address version you want to use.

  • IP Address: Specify the addresses of all hosts/networks that can access the ASA using HTTP.

  • Netmask: Specify the subnet mask for the network.

Note

To remove a host, you can click the delete icon under Actions.

Step 6

Click Save.


The ASA HTTP server is enabled with the chosen port, and the configured hosts or networks are allowed for management access. If HTTP redirect is in use, the required access rule permits the interface to listen and redirect to HTTPS.