Configure basic DNS settings

Configure DNS on the ASA to enable host name resolution and to support using FQDN network objects in access rules. This task sets servers, the domain name, and DNS lookup interfaces, and then saves the shared system settings policy.

You need to configure a DNS server so that the ASA can resolve host names to IP addresses. You also must configure a DNS server to use fully qualified domain names (FQDN) network objects in access rules.

Before you begin

Follow these steps to configure basic DNS settings on the ASA:

Procedure


Step 1

In the edit ASA system settings page, click DNS in the left pane.

Step 2

Uncheck the Retain existing values checkbox to configure the values for the shared ASA system settings policy.

Important

If the Retain existing values check box is selected, you can't configure the values as the fields are hidden. Security Cloud Control uses the existing local values of the ASA device for this setting and doesn't inherit from the shared policy.

Step 3

In the DNS section, click The configuration interface for basic DNS settings, highlighting options for IP version selection, DNS server IP address entry, and interface name specification for DNS lookup. to configure servers.

  • IP Version: Select the IP address version you want to use.

  • IP Address: Specify DNS server's IP address.

  • Interface Name: Specify the interface where the DNS lookup should be enabled.

Note

Ensure the interface name specified here is the same on the ASA devices associated with this shared system settings policy.

Step 4

Click Save.

Step 5

In the Domain name field, specify the domain name for the ASA.

The ASA appends the domain name as a suffix to unqualified names. For example, if you set the domain name to “example.com” and specify a syslog server by the unqualified name of “jupiter,” then the ASA qualifies the name to “jupiter.example.com.”

Step 6

In the DNS Lookup section, click The image illustrates the configuration interface for basic DNS settings on ASA devices, highlighting the importance of matching interface names and enabling DNS lookup for proper communication with DNS servers. and specify the interface name.

If you do not enable DNS lookup on an interface, then the ASA will not communicate with the DNS server on that interface. Make sure to enable DNS lookup on all interfaces that will be used to access DNS servers.

Note

To remove a configured interface, you can click the delete icon under Actions.

Step 7

Click Save.


DNS servers, domain name, and DNS lookup interfaces are configured and saved. The ASA resolves host names to IP addresses, and FQDN network objects in access rules operate correctly using the configured DNS settings.