Configure ASA VLAN subinterfaces
Add a VLAN subinterface on an ASA device through Cisco Defense Orchestrator and prepare it for IPv4 or IPv6 addressing or advanced options.
Use this procedure when managing ASA devices in Cisco Defense Orchestrator and you need to create a VLAN-tagged subinterface from the inventory and interface management views.
Before you begin
Follow these steps to configure ASA VLAN subinterfaces:
Procedure
Step 1 | In the left pane, click . |
Step 2 | Click the ASA tab. |
Step 3 | Select the device you want to modify, and in the Management pane on the right, click Interfaces. |
Step 4 | You can add a subinterface using one of the following methods:
|
Step 5 | In the VLAN ID field, enter the VLAN ID between 1 and 4094. Some VLAN IDs might be reserved on connected switches, so check the switch documentation for more information. For multiple context mode, you can only set the VLAN in the system configuration. |
Step 6 | In the Subinterface ID field, enter the subinterface ID as an integer between 1 and 4294967293. The number of subinterfaces allowed depends on your platform. You cannot change the ID after you set it. |
Step 7 | Continue with one of the following procedures:
|
A subinterface is created with the specified VLAN and subinterface IDs, and it is ready for IPv4 or IPv6 addressing or advanced adjustments. You can then enable the subinterface according to your deployment needs.
What to do next
Complete related procedures as needed.
>